Roger Borg Posted February 24, 2022 Share Posted February 24, 2022 I have a bare wire leading from a speed coil to a switch. It's original, and likely pretty brittle, so electric tape is out of the question. I bought some spray on electric insulation a long time ago, and tried spraying that on a piece of cardboard and transferring it to the wire, but it is very very runny, and I'm not all that confident in its insulating nature unless I do this 10 times or so, now having read the reviews. That said, I wanted to know if anyone has ever used silicone as an electrical insulator. From what I've read, and in my experience with HV, it can be used. But I didn't know if anyone had ever done so in a similar situation, or if there is some side effect that I'm not considering. Thanks... Quote Link to comment Share on other sites More sharing options...
Dave McManaman Posted February 25, 2022 Share Posted February 25, 2022 Could you just use new wire, soldering on to one end and then shrink wrapping that connection? Quote Link to comment Share on other sites More sharing options...
Roger Borg Posted February 25, 2022 Author Share Posted February 25, 2022 Because the original wire was still intact, I wanted to preserve it rather than chop apart and splice. Silly I know, but seemed better to resheath the original than cut it apart. Either way, still fragile stuff. Will post a pic tomorrow... 1 Quote Link to comment Share on other sites More sharing options...
Stan Adams Posted February 25, 2022 Share Posted February 25, 2022 I use really thin heatshrink 3 Quote Link to comment Share on other sites More sharing options...
Chris Krenke Posted February 25, 2022 Share Posted February 25, 2022 I would try liquid electrical tape Quote Link to comment Share on other sites More sharing options...
Craig Meier Posted February 25, 2022 Share Posted February 25, 2022 Why don’t you cut it slip some heat shrink over it soldier it back together. Quote Link to comment Share on other sites More sharing options...
Anthony Lindsey Posted February 25, 2022 Share Posted February 25, 2022 was the wire bare to begin with? I see many bare wires from the speed coil to the switch selector that were left bare when new. Quote Link to comment Share on other sites More sharing options...
Roger Borg Posted March 7, 2022 Author Share Posted March 7, 2022 Anthony, yes the wires were covered with braided cloth. Everything appears untouched. I've put 10 coats of the spray liquid electric tape onto the bare wire, and get no continuity reading when I touch either side of the sprayed wire, so seems this was sufficient to insulate it. Anything I'm not considering, or will this be ok long term? Still would prefer not to cut and solder and shrink wrap if the original connection is fine. That said, on another note, was it standard to have the wires soldered at the switch from the factory? All the other fans I've worked on have bolts that hold down the wires. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.