Leaderboard

Jamie has worked really hard to make the forums a bit more user friendly. We now have a section for birthdays, congratulatory messages, etc under the Community section. Box fan tab now includes industrial fans, circulators, belt drives, etc. We hope you like the changes & hope it makes things more user friendly. I will be moving posts around to new areas the next several days, so be patient. THANKS JAMIE!

Saw this, it's smaller than the normal one's I've seen or at least I think it is

Amazing to see that example with no bends, kinks, or warps in the aluminum grilles !

Early alternating current.

June 13,14,15.

I do initially clean with toilet bowl cleaner and again before clearing. Purpose of initially cleaning is to knock off any film over past 100 years that could allow paint from adhering in places. Paint that lifts when wet sanding is no fun. Hot water and toilet bowl cleaner used again once finished to strip off any polish and grit on painted fields before clearing. I never use anything aerosol. Purpose of airbrush is to have full control of fluid flow and anything aerosol never compares. Start by cleaning as above with toilet bowl cleaner. Sometimes scrubbed with toothbrush if crusty. Rinse with hot water for clean surface. Airbrush base color or flat enamel. Enamel is harder vs acrylic or mystery paints found in aerosols. Remove paint from high brass areas with small pieces of 1000 grit sand paper wet sanded with soap water. Soapy water allows sand paper to glide easily. Any areas of paint removed unintentionally are spot touched up with airbrush. This could be as small as 1/8” area vs starting over again. Once high areas knocked down with 1000 grit then use 1500 and 2000 to remove sanding marks. After that a non solvent based polish and cotton tshirt. The tag or badge will have grit and polish residue. To clean use toilet bowl cleaner / hot water again. Then clear. When I use lacquer will do a light dusting then additional dustings with airbrush until satisfied. This will lock the surface and prevent wrinkling of paint or bleeding when using light coats. If using urethane generally just one heavy coat. Airbrushes provide control vs anything you will ever find in a can. The idea is to have the thinnest layers of paint that are solid enough to block brass surface and thin enough to easily be removed where needed. Easily touched up when needed. Airbrushes will give you adjustable 1/8” through 1” paint pattern radius. This badge is white primer, white base, pearl layer and then urethane. 4 layers of painted material. It is perfect and took multiple attempts. I also use an airbrush opened up to 1” pattern to lacquer brass blades. Low air pressure does not kick dust into wet lacquer and avoids orange peel both of which work against mirrored brass.