Jump to content

Recommended Posts

Posted

On a 21646, does the neck pivot up and down so angle can be adjusted?

The wing nut goes all the way through, so appears not to, but am I missing something??

If pivoting 90° for wall mounting, still doesnt make sense because no other hole for it to slot through.

Utterly confused (only slightly more than usual)...

Screenshot_20230622-175334_Gallery.jpg

Posted

I had a 21666 where the neck froze in a tilted position. I was told they're pot metal and it swells. Took a lot of gentle persuasion and oil to free it up. Once free it was fine. I may have done a little sanding on all parts to make it smooth, I don't remember. Be careful,you'll end up with pieces...

  • Like 1
Posted
22 hours ago, Michael Rathberger said:

I had a 21666 where the neck froze in a tilted position. I was told they're pot metal and it swells. Took a lot of gentle persuasion and oil to free it up. Once free it was fine. I may have done a little sanding on all parts to make it smooth, I don't remember. Be careful,you'll end up with pieces...

Gotcha, thanks for the reply.

It's perfectly level, may just let sleeping dogs lie...

Posted

There should be a few holes in the neck piece.  Did you pull the bolt out and try the 90 degree angle?

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...