Anthony Lindsey Posted February 6, 2022 Share Posted February 6, 2022 Were these tight when they were new? Everyone I have encountered is loose to some varying degree. Quote Link to comment Share on other sites More sharing options...
David Kilnapp Posted February 6, 2022 Share Posted February 6, 2022 I've often seen that this is the case and have had good luck using JB Weld around the underside which seems to lock the shaft into place. Quote Link to comment Share on other sites More sharing options...
Anthony Lindsey Posted February 7, 2022 Author Share Posted February 7, 2022 Ok, thanks. But were they loose by design or become loose over time? Quote Link to comment Share on other sites More sharing options...
Lane Shirey Posted February 7, 2022 Share Posted February 7, 2022 (edited) Pot metal joined to steel. Not the best mechanical connection given the weight of the motor. Daves fix is likely the best. Edited February 7, 2022 by Lane Shirey Quote Link to comment Share on other sites More sharing options...
Paul Carmody Posted February 7, 2022 Share Posted February 7, 2022 (edited) JB Weld.The duct tape of fanmanship. I've had success with what David suggested. Edited February 7, 2022 by Paul Carmody Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.